9 Easy Steps On How To Install a Hardwired GPS Tracking Device

As an illustration, the column is a power source which is used to ensure a power supply.

Continually, these are the following steps in order to hardwire the GPS to the vehicle:

1. Find a wired power source where you will attach the wiring harness to a tracker receiver
2. Try removing the insulation from the wire with the source for about an inch
3. Poke through the wire with a sharp object in order to create a circle
4. Take the red wire and take an inch off the insulation of the device.
5. Next, twist both of the ends of the wire and then poke through the circle on the vehicle’s power source.
6. Take the circle and twist the wire around it. Then take an electrical tape and wrap it in order to secure it.
7. Find the ignition of the vehicle’s wire and connect to the white wire of the unit.
8. In the end, you need to connect both, the vehicle to the tracking unit ground wires together.